W1siziisijiwmtuvmdivmtivmtyvmzyvmdqvnteyl0f2yxrhci5wbmcixsxbinailcj0ahvtyiisijmwmhgzmdajil1d?sha=40d429a2ffd553af
First print update! \o/ I had to reduce the speed to around 50mm/s, which sadly added another 6 hours to the print time.

First print update! \o/

I had to reduce the speed to around 50mm/s, which sadly added another 6 hours to the print time. At least it now fills the layers correctly again, which definitely is a plus. I’ve also increased the print temperature because otherwise the extruder wasn’t extruding properly, however, I think this may have contributed to my biggest problem…

Anyway, here is how it looks:

Print progress

The C&C Mac which controls the printer right now is doing good as well:

C&C Mac

However… I have some huge warping issues, as can be seen in this picture:

Warping

I’ve reduced the bed temperature to 55°C already and the warping hasn’t increased in the last couple of hours, but, as you can see the build is already skewed on the edges. So far I’ve used up ~25m of filament, I could cancel and restart the print, this time with glue and a brim layer. I wish I had done that from the get go, but I have never experienced warping that bad.

Edit I just cancelled the print. 13 hours for the trash, fuck.

This document is webmention enabled.